ABS (ABS-M30 Type), 184in3, Extra Large Reel of Filament for Stratasys® Fortus® Printers
Triton™ ABS is 100% compatible with your Fortus® printers using the ABS-M30 settings. This ABS has been tested on Stratasys printers and offers excellent results when compared to Stratasys® ABS-M30. We provide the EEPROM chip for your printer (Classic and Plus Style Chip). All you need to do is load your canister, install the chip, and start printing! We are so sure you will like this ABS, that we offer a 100% money back satisfaction guarantee on your purchase. Refill and save $$$ over Stratasys ABS-M30.
Print over the entire weekend without worries when you use our 184in3 reels on your Stratasys® Fortus® printer.
Compatible with the following printers:
Fortus® 360mc (Classic & Plus)
Fortus® 380mc (Plus)
Fortus® 400mc (Classic & Plus)
Fortus® 450mc (Plus)
Fortus® 900mc (Classic & Plus)
Fortus® F900 (Plus)
2 Reviews Hide Reviews Show Reviews
This stuff runs better than the standard filament for Stratasys. Our printer runs every day sometimes through the night for several days on end. I am thoroughly impressed.
I was skeptical when I loaded this in the canister to print, but the results speak for themselves. I would upload a picture if I could.
If you're on the fence about this filament--don't be. It lays down a straight and true bead of filament and works wonderfully. Not to mention cost savings.
A real life saver. We were going to sell our Fortus until we found these guys. Runs like M30.